One or three axes do not walk or abnormal

1. control cards are loose or failure;

2. the corresponding axis of drive failure; corresponding axis stepper motor fault;coupling corresponding to the broken or loose: the corresponding screw fractureor screw-nut failure; corresponding to the slider axis fails;

3. drive in the fine fraction, currents, and software settings are not the same.

Second, the z axis control

1. control cards are loose or failure; z axis motor fault:

2. static; drive interference;

3. incorrect file path;

4. computer system problems or viruses or errors.

Third, the error

1. control cards are loose or failure; drive; step motor failure; motor fault; data line failure;

2. electrostatic interference, incorrect path; coupling breakage or loosening; rapidprocessing;

3. the computer system problem or a virus.

Four, carved two-tone

1. control cards are loose or failure; drive failures or inconsistent with the softwaresettings of current subdivision; z axis motor fault; step motor failure; the spindle motor fault;

2. the converter interference or incorrect data set; static; computer viruses or system problems.

Five, carved

1. Control card failure, cable failure;

2. the converter interference, static;

3. incorrect file path; a drive failure or current subdivision setting is wrong; there sets a software problem;

4. computer viruses or system problems.

Six, wash the end of inequality

1. the spindle and table is not normal, need correction;

2. the tool in question; z axis drive problem control card is defective.

Seven, spindle stop

1. the spindle internal short-circuit; axis or data cable short circuit;

2. the inverter parameter settings are incorrect or its failure, control card failure; current screening.

Eight, the spindle turn sound not normal

1. frequency converter setting is incorrect; the spindle does not turn; the spindle itself has problems;

2. spindle water (water cooling) cause damage to the bearing oil.